|
|
| SOLAR CHARGE CONTROLLER for home system(EPHC) |
| |
 |
SOLAR CONTROLLER
FOR SOLAR HOME SYSTEMS
EPSOLAR’s high quality and reliability is now available in a low cost solar controller. The EPHC Controller is ideal for rural electrification systems. It provides many features and benefits.
BENEFITS OF A SOLAR CONTROLLER
It is important to include a controller in a solar power system.
Reduce Cost of Battery Replacements
The low voltage disconnect will increase battery life. The loads are automatically disconnected when the battery is low and automatically reconnected after the battery is recharged.
Complete charging will increase battery life and storage capacity.
The controller will maximize the amount of solar energy into the battery and avoid drying out the battery.
Provides Useful Information
LEDs display status information and battery level which helps the user to battery operate the solar power system.
ADVANTAGES OF THE EPHC CONTROLLER
EPHC controller has many advantages compared to other controllers:
Low Cost
The EPHC was specifically designed to meet the needs of the rural electrification market. The low cost resulted from using the latest electronic technology and high volume manufacturing.
High Reliability
EPSOLAR is a dynamic manufacturer of solar charge controllers. All our controllers are designed for high quality and high reliability. The EPHC controller has a low failure rate and will last a long time, and got very good feedback from customers until now.
Electronic protections
The EPHC has build-in electronic fused that do not require replacements. Any wiring mistakes during installation will not damage the controller.
Tropicalization
The EPHC electronics are protected with moisture-tight coating(APL lacquer), minimizing damage from humidity and from nesting insects.
Easy to use
The EPHC controller is fully automatic and requires no adjustments or user selections.
RATINGS: 12/24 VOLT auto-work
EPHC-5: 12 VOLT or 12/24 VOLT auto work, 5 AMPS
EPHC-10: 12 VOLT or 12/24 VOLT auto work, 10 AMPS
Regulation point: 14.4 Volt Self-consumption: 6mA maximum
Low voltage disconnect: 11.1 Volt Dimension: 140x90.5x27mm
Low voltage Reconnect: 13.1 Volt Terminals: for wire sizes to 2.5mm2
Type of Charging: series PWM, state of charge(SOC) Weight: 250g
4 stages Bulk,PWM,Boost and Float Temperature: -35℃ to +55℃Electronic protections: short circuit and over current Humidity: 100% non-condensing
-solar and load Enclosure: IP 22
Reverse polarity-solar,load & battery Case: ABS
Reverse current at night Compliance: CE world Bank
High voltage-load
Lightning-solar, load, battery
Tropicalization: circuit board-conformal coated
Terminals-corrosion protected
LED indications: Green charging
Green-Yellow-Red battery levels
Red low voltage warning and disconnect
Green-Yellow-Red battery levels
All 3 LEDs blink-to show mistakes |
|
chinapower.com
